1. Solid Analyzer 1 set 1) Minimum Force : 0.0005 N 1) Maximum Force : 35 N 2) Force Resolution : 0.00001 N 3) Dynamic Displacement Range : ±0.00005 to ± 1.5 mm 4) Displacement Resolution : 1 Nanometer 5) Modulus Range : 103 to 3 x 1012 6) Modulus Precision : ± 1% 7) Tan Delta Sensitivity : 0.0001 8) Tan D elta Resolution : 0.00001 9) Frequency Range : 2 x 10-5 to 100 Hz 10) Temperature Control : Forced Convection Oven 11) Temperature Range : -150 to 600 °C 12) Heating Rate : 0.1 to 60 °C/min. 13) Cooing Rate : 0.1 to 60 °C/min. 14) Isothermal Stability : ± 0.1 °C 2. Temperature Options 1 set 1) Forced Convection Oven 1) LN2 Controller 2) Low Pressure Liquid Nitrogen Vessel, 160 Liter with Cart 3. Test Geometries 1 set 1) Film / Fiber Geometry 2) Cantilever Bending Geometry 3) Parallel Plate Compression Geometry 4) Shear Sandwich Geometry 5) Immersion Geometry : Includes Tension and 15 mm diameter Compression Fixtures. Also includes 10 mm, 15 mm, and 20 mm 3-point bending fixtures. 4. Miscellaneous Accessories 1 set 1) Air Dryer 2) Four-Port Ethernet Router 3) Forced Convection Oven Camera 5. Dielectric Thermal Analysis(DETA) Options 1 set 1) DETA Accessory Kit 2) two 25 mm DETA Geometries 3) Agilent 4285A LCR Meter (frequency range: 75 kHz. to 30 MHz.; AC test signal (potential) 0.005 to 10 Volts (115 / 230V; 50 / 60 Hz)