1. One (1) fully coaxial Furnace Assembly, including:
 Furnace Head Assembly with;
o Electromechanical head lift
o Mild steel head weldment with stainless steel inner liner
o Linear roller bearing guideway
 Ballscrew Assembly with Manual Stub Clamp
 Ram Drive Assembly
o Single input reducer with close coupled servo drive

2. One (1) Single Station Base Frame Assembly:
 One (1) integral melt station cart to move the base plate in and out from under the furnace head
 One (1) Copper Base Plate assembly, sized for maximum 300 mmf crucible

3. One (1) Set Water System components consisting of:
 Feed and drain manifolds and instrumentation for crucible cooling, power supply cooling, and auxiliaries

4. One (1) Generation 7 Custom Control System including:
 Control Console
o Pentium computer (latest technology) with Ethernet card for LAN communication
o 530 mm (21 inch) TFT color monitor
o Uninterruptible power supply

5. One (1) Power Supply:
 10 kA Saturable Reactor Power Supply system
 Input from dedicated 4160 V, 1 phase, 60 Hz primary +10%/-5%
 Power Factor Correction capacitors to 0.90 at full power
 Bus and Water Cooled Cables

6. One (1) Motor Control Panel
 Power distribution to all auxiliaries from 380 volt, 3 phase, 60 Hz input

7. One (1) Load Cell Weighing System:

8. One (1) Pre-Melt Evacuation System:

9. Set Manuals:
 Operations manual in .PDF format on CD and installed on control PC
 AMC manual in .PDF format on CD and installed on control PC
 Vendor Component manuals in .PDF format on CD and installed on control PC

10. Set of Assembly Drawings and Schematics on CD-ROM:
 Copy of ‘As Built’ revisions in .PDF format